Easy tapping attachment with drill chuck for tapping and reaming Size:MT3 This is a square insert

This is a square insert used on cast iron for machining

taper and roundness• Steel body and interchangeable carbide anvils• Extension rods and washers for fine adjustment in sizes to select a specific range• Dial indicator fully protected by a rugged cover

This defence-grade hydraulic oil provides excellent corrosion protection and compatibility with a wide range of seals and materials

Extended Tool Life – Resistant to wear

Grooving Range: 30–60 mm diameter

Easy tapping attachment with drill chuck for tapping and reaming Size:MT3 This is a square insertEasy Tapping Attachment with Drill Chuck for Your Lathe Machine the Sleeve Gets into Morse Taper of Your Lathe's Tailstock. Mount the Drill Chuck on the Threaded Arbor Having M14 X 1. 25 Thread. Slowly Move the Inside Shaft with Mounted Chuck (Having Desired Tap) Away from the Sleeve Through the Cross Bar Circular Manner, Manual Feed for Full Control. Made of Quality Tool Steel. Shank Is Precisely Ground Chose from Available Morse Tapers 2 Mt 3 Mt